Product Description
Wi-FIRE: WiFi Enabled PIC32MZ Microcontroller BoardProduct Description:Building on the previous successes with the WF32, the Wi-FIRE uses the same 43 available I/O pins, 12 analog inputs, 3.3 operating voltage, 4 user LEDs, potentiometer, buttons, uses MRF24 on-board wireless module, microSD Card, dedicated SPI Signals and high efficiency switching 3.
3V switching power supply for low-power operation.
The Wi-FIRE is significantly faster than its WF32 counterpart, with 200 MHz operation speed, 2MB of Flash, 512kB RAM, High-Speed USB and a 50MHz SPI.
The PIC32MZ core includes the MIPS M5150 CPU Core from OpenOCD.
The Wi-FIRE can be programmed using MPIDE and with the addition of a compatible in-system programmer/debugger, can be used with the more fully featured/advanced Microchip MPLAB® X IDE.
Connector(s): USB A micro-B cable (USB cable not included), USB Serial Converter, microSD card connectorProgramming: MPIDE, MPLAB X (with separate programmer), OpenOCD for hardware debuggingFeatures:• Microchip® PIC32MZ2048EFG100 microcontroller• 2MB Flash memory• 512KB RAM• 200 MHz maximum operating speed• 50 MHz six 4-wire SPI, six UART modules, five I2C modules, PPS• 10-bit ADC module: 500 Ksps rate with one Sample and Hold (S&H) circuits, up to 40 analog inputs• 43 available I/O pins with on-board user interfaces• 3.
3V operating voltage• 3.
3V and 5V regulators• 12 analog inputs• PC connection uses a USB A to micro-B cable (not included)• USB 2.0 Full-Speed / Hi-Speed OTG controller with A and micro-AB connectors• MicroSD card connector• Four LEDs, two Pushbuttons, one Potentiometer• Fully supported by MPIDE• For more advanced users, MPLAB X IDE is available with a separate programmer• EJTAG header for external debugging• Microchip MRF24WG0MA WiFi module• DSP-enhanced core: Four 64-bit accumulators, single-cycle MAC, saturating and fractional mathUser documentation, software, and tools support are available from OpenOCD.
What's Included:• Wi-FIRE• Custom Digilent cardboard box with protective foam
