Description
Motion detector insert 160 degrees, 3 wires, 2200W, 1.1m
The motion detector with a 10 A switch detects moving heat sources (e.g. people) and can switch on ohmic, inductive or capacitive loads for an adjustable time. Suitable for installation in a 60 flush-mounted box. With screw terminals. Without claws, for screw fastening.
- Automatic mode: Automatic switching on of loads when motion is detected and depending on the ambient brightness (default setting).
- Manual mode: Switching on of loads on the device, regardless of the ambient brightness.
- Operation with extension: (mechanical button / other motion detectors).
- Detection brightness: 5-500 lux (factory setting 50 lux).
- Delay time: 1 second - 30 minutes (factory setting 5 minutes).
- Test mode: Checking motion detection and installation.
- Secondary operation: Sending a switching command to a primary device when movement is detected.
- Rated voltage: AC 230 V, 50 Hz.
- Rated current: max. 10 AX, cos=0.6.
- Outputs: 1x closer.
- Max. Switching capacity per channel: LED: 200 W, incandescent lamps: 2200 W, HV halogen lamps: 2000 W.
- LV halogen lamps with magnetic transformer: 500 VA.
- Electronic transformers: 1050 VA.
- Energy saving lamps: 200 W.
- Motor load: 1000 VA.
- Neutral conductor: required (3-wire system).
- Protection: 16 A miniature circuit breaker.
- Cable area: max. 2x2.5 mm², 0.5 Nm.
- Extension: individual button, unlimited number, max. 50 m.
- Detection range: 160°.
- Range: approx. 8 m.
- Control elements: 1 button.
- Display elements: 1 LED, (behind the lens ).
- Dimensions (width x depth x height): 71 mm x 49 mm x 71 mm.
