Arty Z7-20: APSoC Zynq-7000 Development Board for Makers and Hobbyists
Product Description:
The Arty Z7 is a ready-to-use development platform designed around the Zynq-7000™ All Programmable System-on-Chip (AP SoC) from Xilinx. The Zynq-7000 architecture tightly integrates a dual-core, 650 MHz ARM Cortex-A9 processor with Xilinx 7-series Field Programmable Gate Array (FPGA) logic. This pairing grants the ability to surround a powerful processor with a unique set of software defined peripherals and controllers, tailored by you for whatever application is being conquered. The design process is very straightforward and provides a systematic path between defining your custom peripheral set and bringing it's functionality up to a Linux OS running on the processor. Digilent provides a number of materials and resources for the Arty Z7 that will get you up and running with this process quickly.
FPGA-Features:
• FPGA part: XC7Z020-1CLG400C
• 1 MSPS On-chip ADC: Yes
• Processor: Dual ARM Cortex A9
• Look-up Tables (LUTs): 53,200
• Flip-flops: 106,400
• Block RAM: 630 KB
• Clock Management Tiles: 4
• Available Shield I/O: 49
ZYNQ Processor
• 650MHz dual-core Cortex-A9 processor
• DDR3 memory controller with 8 DMA channels and 4 High Performance AXI3 Slave ports
• High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
• Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
• Programmable from JTAG, Quad-SPI flash, and microSD card (Micro USB cable not included).
• Programmable logic equivalent to Artix-7 FPGA
Memory:
• 512MB DDR3 with 16-bit bus @ 1050Mbps
• 16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-48/64™ compatible identifier
• microSD slot
Power:
• Powered from USB or any 7V-15V external power source
USB and Ethernet:
• Gigabit Ethernet PHY
• USB-JTAG Programming circuitry
• USB-UART bridge
• USB OTG PHY (supports host only)
Audio and Video:
• HDMI sink port (input)
• HDMI source port (output)
• PWM driven mono audio output with 3.5mm jack
Switches, Push-buttons, and LEDs
• 4 push-buttons
• 2 slide switches
• 4 LEDs
• 2 RGB LEDs
Expansion Connectors
• Two standard Pmod ports
• 16 Total FPGA I/O
Arduino/chipKIT Shield connector
• Up to 49 Total FPGA I/O (see table above)
• 6 Single-ended 0-3.3V Analog inputs to XADC
• 4 Differential 0-1.0V Analog inputs to XADC
What's Included:
• Arty Board Zynq 7000 APSoC: Arty Z7-20 (Micro USB cable not included).
• Custom Digilent cardboard box with protective foam
