DSH-3-A, Distance set, Truss head, 4.8 x 50 (17-20), Partial thread (L1), SIT® 20, A2 stainless steel/plastic, pickled, passivated, lubricated, SD19, 100 Pcs.
DESCRIPTION
DSH-3-A Distance set - The complete package
ADVANTAGES:
Easy-to-install one-person fastening solution replaces the conventional, sometimes cumbersome two-person fastening version.
Complete package = Set comes fully pre-assembled with screw, seal and sleeve and can be processed straight away.
Significantly improved sealing (especially on corrugated profiles). Large umbrella sealing seals all over the area and adapts perfectly to the profiles during compression.
PRODUCT FEATURES:
SIT®
Quickly access the drive
No tumbling motion
Maximum power transmission without the risk of over-tightening
Can be used with standard TX bit
Truss headLarge flat contact surface
High contact pressure
Perfect fit and neat finish
EPDM sealing washerLong-lasting
UV-stable
Prevents the ingress of water and provides a long-lasting seal for the connection
Umbrella sealingLong-lasting
UV-stable
Excellent adaptation to corrugated profiles
Expanding spacer sleeveStabilises the profile from the bottom
Replaces conventional spacers
Captive and pre-assembled on screw
Wood screw threadSecure hold in wood
FIELDS OF APPLICATION:
Fasteners for fixing light panels to wooden substructures.
Carports, pergolas, canopies
PROCESSING RECOMMANDATIONS:
1. Pre-drilling profile sheets using step drill (dia. 10 mm article 00A423S010-410040L-2, dia. 12 mm article 00A423S010-512040L-2).
2. Insert the distance set into the panel until the screw and the sleeve are resting on the substructure.
3. When screwing into the substructure, the sleeve collar must be positioned below the profile sheet so that it can expand.
4 Tighten until the washer is slightly compressed.
The specifications of the light panel manufacturers must always be observed.
PRODUCT INSTRUCTIONS:
Set consists of stainless steel A2 façade panel screw 4.8 x 50 mm, EPDM umbrella sealing dia. 19 mm and expanding sleeve.
Clamping area corresponds to profile height.
Pre-drilling of the profile sheet with the REISSER step drill dia. 10 mm (article no. 00A423S010-410040L-2).
