Description
ESD push-rod clamp with protective cap and handle made of electrostatic dissipative material.
The ESD push rod clamp was specially developed for use in ESD protection zones (EPA - electrostatic protected area) for work on electrostatically sensitive components, assemblies or devices in accordance with the DIN EN 61340-5-1 standard.
Product benefits:
- Without angled foot.
- Push and pull tensioner (push rod and hand lever running the same way)
- Long push rod guide with fastening thread and nut
- Galvanised and passivated
- Rivets of stainless steel running in case-hardened bearing bushes
for sizes 2 and 3- Lever parts and push rod clamps made of quenched and tempered steel
- Bearing points greased
- Push rod clamps with thread on the face for direct installation in sheet metal walls or in fixtures
- Ergonomic, oil-resistant handle with large hand rest and soft component
- Complete with tempered, zinc-plated pressure screw no. 6880ESD
Technical information:- Discharge resistance according to DIN IEC/TR 61340-5-2 between 10^4 and 10^9 Ohm
- Discharge time according to DIN IEC/TR 61340-5-2 < 2 seconds
- Surface voltage (electric field strength) according to DIN EN 61340-5-1 < 100 volts
Note: The ESD push rod clamp is not insulating. It must not be used in areas where work is carried out with open voltages.
