Product Description
"The MD6 serial multi GNSS Receiver based on u-blox 8 chipset has a built-in antenna for high sensitivity.
You can use this GNSS Receiver with a laptop and a suitable routing software for navigation.
The MD6 universal connector enables the connection of optional USB or serial connecting cables.
The NL-803P GNSS receiver can be installed onto different vehicle roofs (car, truck, bus etc.
) by using the included installation material.
Thus it can perfectly fit into the vehicle concept, due to its design.
Technical details Connector: MD6 Navilock plug (USB or serial cable are optional available)Chipset: u-blox 8 EVA-M8QFrequency: GPS: L1, 1575.4200 MHz GLONASS: L1, 1602 (k x 0.5625) MHz BEIDOU COMPASS: B1, 1561.0980 MHz GALILEO: E1, 1575.4200 MHz QZSS: L1, 1575.4200 MHzAccepts the signals of up to 72 satellites at the same timeSupports AssistNow online / offline, SBAS (WAAS, EGNOS, QZSS and MSAS)Supports NMEA 0183 protocols: GGA, GSA, GSV, RMC, VTGAuto Baud Rate up to 115200 bpsPPS signal on pin 6 (LVTTL 3.3 V)Update rate: single GNSS: 18 Hz (e.
g.
GPS solo) multi GNSS: 10 Hz (e.
g.
GPS+GLONASS)Sensibility: max.
-164 dBmProtection class: IPX7Operating temperature: -10 °C ~ 50 °CPower supply: 5 V DCCurrent consumption: max.
45 mACold start in ca.
26 secondsHot start in ca.
1 secondPositioning accuracy: 2.5 m CEP (Circular Error Probable) and 2 m CEP with SBASCable length: ca.
5 mDimensions (Ø x H without screw thread): ca.
62 mm x 21 mmSystem requirements Android 10.0 or aboveChrome OS 90.0 or aboveLinux Kernel 5.8 or aboveWindows 10/10-64/11MD6 connection cablePackage content MD6 serial receiverMounting material: stainless steel nut and washerPackage Box"
