Product Description
"PROG-S for Atmel AVR, STM32, NXP and LPC controllersA real all-rounder.
Three different programming modes allow it to be used in a variety of applications.
The Atmel AVR controllers and ST and NXP Cortex-M controllers can be programmed via the ISP interface and UART bootloader respectively.
A DIP switch can be used to select between Atmel AVR, STM32 and NXP/LPC.
As a special treat, a fourth mode—which emulates a USB-to-serial converter—is included.
NEW for AVR mode! The adaptive bit-rate adjustment automatically detects and adjusts SPI bit rates that are set too high.
Target voltage supply is also possible via the DIL switch.
This voltage can be set to 5 V or 3.3 V and can be switched on or off.
This helping hand for professionals, hobbyists and ambitious novices is delivered in an original laser-cut Plexiglas® housing.
Electronics and housing are made entirely in Germany.
Two integrated status LEDs indicate the current status of theprogrammer.
Software support:• AVR Studio 4, AVR Studio 5• ATMEL Studio 6 and 7• AVRDUDE• Bascom with setting options->Programmer = STK500: C:\Programs\Atmel\AVR Tools\STK500\stk500.
exe and installed AVR Studio• Flash Magic for NXP controllers• STM32 Flash loaderSupports the following microcontrollers:• Atmel ATtiny• Atmel ATMega• Atmel AT90xx• All other AVR controllers that support the SPI programming interface• All STM32 Cortex-M controllers with UART bootloader• All NXP/LPC Cortex-M controllers with UART bootloaderTechnical data:• Four different operating modes: AVR, STM, NXP/LPC and USB serial converter up to 1 Mbit• Very fast programming cycle thanks to onboard processor and sophisticated firmware• Adaptive bit-rate adjustment automatically detects SPI bit rates that are set too high• Target power supply of 3.3 V maximum 120 mA, 5 V maximum 500 mA, depending on the PC• Does not require power supply from the target• Command-compatible with STK500• USB 2.0 compatible• Two LEDs for function control• Very fast data transfer at 12 MB• Data transfer configurable using software, slower speeds selectable• Own consumption: approx.
15 mAIncluded:• ISP programmer in a coloured Plexiglas housing (colour may vary)• ISP 10-pin connector, standard Atmel, approx.
15 cm• USB mini cablePlease note:• This programmer cannot program ATXmega controllers with the PDI interface or ATtiny 4/5/10 with the TPI interface• NXP controllers with 8051 core (LPC9xx) are not supported by this programmer• STM8 controllers are not supported by this programmerInstallation information:Only the ""PROG-S2-ISP.
ZIP"" file is required to install the appropriate virtual COM port driver.
Extract the files from the ZIP file to the.
.
.
