Often you have to add additional flux in gel form for optimal solder results. Despite of various NO-CLEAN products, the requirement of cleaning increases more and more to clean the components after soldering. And just here the miracle starts! With which cleaning products you can clean without increasing the chemical pot on the PCB?
With FL 22 W flux gel flux is distributed precisely and concertedly by an irrigator with a plastic tip on the spots to be soldered. The known effect, that fluxes with their portion of alcohol quickly evaporate, doesn't happen immediately with the flux.
The compound of the flux corresponds to OR L0. The cleaning should be done with hand warm water without any chemicals. All flux residues have to be washed and removed complete.
Content: 5 ml
Flux type: DIN EN 29454 / 1.2.3., OR L0
Advantages: * water soluble flux
* little amount will be enough for excellent solder results
* easy handling
* handy irrigator form
* very well suitable for Fine-Pitch and SMD uses
* perfect soldering results using hot air and soldering with direct
contact, especially with MINI FLOW soldering tips
* fast repair is made possible
* for washing no further chemicals are recommended, only water
