PROG-S for Atmel AVR, STM32, NXP and LPC controllers
A real all-rounder. Three different programming modes allow it to be used in a variety of applications. The Atmel AVR controllers and ST and NXP Cortex-M controllers can be programmed via the ISP interface and UART bootloader respectively. A DIP switch can be used to select between Atmel AVR, STM32 and NXP/LPC. As a special treat, a fourth mode—which emulates a USB-to-serial converter—is included.
NEW for AVR mode! The adaptive bit-rate adjustment automatically detects and adjusts SPI bit rates that are set too high.
Target voltage supply is also possible via the DIL switch. This voltage can be set to 5 V or 3.3 V and can be switched on or off.
This helping hand for professionals, hobbyists and ambitious novices is delivered in an original laser-cut Plexiglas® housing. Electronics and housing are made entirely in Germany. Two integrated status LEDs indicate the current status of the
programmer.
Software support:
• AVR Studio 4, AVR Studio 5
• ATMEL Studio 6 and 7
• AVRDUDE
• Bascom with setting options->Programmer = STK500: C:\Programs\Atmel\AVR Tools\STK500\stk500.exe and installed AVR Studio
• Flash Magic for NXP controllers
• STM32 Flash loader
Supports the following microcontrollers:
• Atmel ATtiny
• Atmel ATMega
• Atmel AT90xx
• All other AVR controllers that support the SPI programming interface
• All STM32 Cortex-M controllers with UART bootloader
• All NXP/LPC Cortex-M controllers with UART bootloader
Technical data:
• Four different operating modes: AVR, STM, NXP/LPC and USB serial converter up to 1 Mbit
• Very fast programming cycle thanks to onboard processor and sophisticated firmware
• Adaptive bit-rate adjustment automatically detects SPI bit rates that are set too high
• Target power supply of 3.3 V maximum 120 mA, 5 V maximum 500 mA, depending on the PC
• Does not require power supply from the target
• Command-compatible with STK500
• USB 2.0 compatible
• Two LEDs for function control
• Very fast data transfer at 12 MB
• Data transfer configurable using software, slower speeds selectable
• Own consumption: approx. 15 mA
Included:
• ISP programmer in a coloured Plexiglas housing (colour may vary)
• ISP 10-pin connector, standard Atmel, approx.15 cm
• USB mini cable
Please note:
• This programmer cannot program ATXmega controllers with the PDI interface or ATtiny 4/5/10 with the TPI interface
• NXP controllers with 8051 core (LPC9xx) are not supported by this programmer
• STM8 controllers are not supported by this programmer
Installation information:
Only the ''PROG-S2-ISP.ZIP'' file is required to install the appropriate virtual COM port driver. Extract the files from the ZIP file to the...
